Tell us about yourself!
You don't list any sources but ebay lists these as welding filler rods at $3 each ...
Nice designs but don't magnets "disable" credit cards?
I would make the plexiglass over the chisels extend down to guard the blades and any passing fingers.
The underside of whatever table you're sitting at.
Lead melts at 621.4°F, 327.5°C
Nice. Is the bottom weighted? It looks like it could tip over with some enthusiastic cat-tivety.
stick a piece of PSA sandpaper to the base of other machines.
I'm concerned with the lack of fastening to the base and the oblique cylinder of your base. I'm talking tipping over while you're wailing away at it.
You need a PFD and a longer paddle.
Number 5 is a bad habit to get into!
PVC -- It's Great for Inventions
Table Saw Class
How to Make a Lei Po'o
Thank you ItsGraGra for pointing this out. The fixed bending edge needs to be set back at least the thickness of the sheet goods or the brake will be 'sprung' when a fold is thrown. This design, with the vertical clamping, would result in the fixed edge being shoved rearwards, the knife edge possibly being swedged up and an inconsistent bend along the middle of the work. Some brake designs use a horizontal bolt adjustment to hold the fixed edge a set distance from the bending line.Thank you Kevanf1, you have put a lot of good work into your construction and Instructable. Locking the clamping edge both verticaly and horozontaly will increase the consistency of your bends.
The platters make good heliographs.
Knex Coin Sorter V2
Automatic 360 Degrees Panorama Shooting Stand
DIY Glow 3D Printer