Tool Rack

6,398

81

5

About: I work in a 32mm cabinet shop, it's terrible.

Plywood scraps and screws.

Share

    Recommendations

    • Gardening Contest

      Gardening Contest
    • Arduino Contest 2019

      Arduino Contest 2019
    • Tape Contest

      Tape Contest

    5 Discussions

    0
    None
    klee27x

    5 years ago on Introduction

    Good idea! My selection of tools didn't want to work with this system. But I like it so much, I tweaked it a little. Drilling a bunch of 1 1/8" holes kind of defeats the purpose, but at least I only had to drill through a 3/16" strip of wood. Your rack supports the bulk of the weight, and it takes only a minute to slap together!

    DSCF5777.JPG
    0
    None
    pfred2

    7 years ago on Introduction

    Putting tools in holes sort of annoys me so I don't do it, I keep my junk in drawers. I did make this rack for screw drivers though. The tools just slide off and on. If I'd taken the picture at a little better angle you could have seen one of my chisel drawers in that wooden toolbox below the rack.

    I want to make a new wooden toolbox one of these days nicer than that one I already made. Fun projects!

    DriverRack.jpg
    0
    None
    awoodcarver

    7 years ago on Introduction

    Very nice I have mine and sons gouges in different old wine boxes ,cardboard and other boxes not the best for the cutting edges