Tell us about yourself!
12V, 2A Uninterruptible Power Supply
Hi Erick , can I have your email address, need to discuss a small project with you .
I wanted to use 3 Wire Digital Pin Setup , if it is applicable to this display
HiI have downloaded the U8glib for Aduino and Installed it , When connecting my Uno , LCD back light lit but no display images , It is using the KS0108 driver .I follwed your 3 wire example and using Pin Out supplied by the manufacture, Kindly see atached PDF file datasheetregards
Hi Josehf MurchisonI downloaded U8glib Library and install , change the code as your diagram , and also wire LCD similar, LCD light up but no text displayed . The Driver the LCD is using is KS0108 , Pinout is different a bit to your .if you supply email I will supply you with the updated Datasheet from manufacturer
Thanks a Million
Hi Josehf MurchisonThanks for a wonderful indestructible, I have salvaged few LCD , but I cant figure this one out with Aduino ,CM12864-8 , here is the link to the datasheet. http://www.cj86.com/upload/201304/15/6348652046392...Can you please help me figure out how to interface it to Aduino Regards
Hi Josehf MurchisonThanks for a wonderful instructable, I have salvaged few LCD , but I cant figure this one out with Aduino ,CM12864-8 , here is the link to the datasheet.http://www.cj86.com/upload/201304/15/6348652046392...Can you please help me figure out how to interface it to AduinoRegards
This are the images of the CM12864-8